Xbee S2 with Programming Shield

This is the XBee XB24-Z7WIT-004 module from Digi. Series 2 improves on the power output and data protocol. Series 2 modules allow you to create complex mesh networks based on the XBee ZB ZigBee mesh firmware. These modules allow a very reliable and simple communication between microcontrollers, computers, systems, really anything with a serial port! Point to point and multi-point networks are supported.

These are essentially the same hardware as the older Series 2.5, but have updated firmware. They will work with Series 2.5 modules if you update the firmware through X-CTU.

• 3.3V @ 50mA
• 300ft (100m) range
• Wire antenna
• Local or over-air configuration
• AT or API command set

Note : Please check with your local laws regarding radio communication. The shield is used to program your Xbee modules using a USB cable.
Built in LEDs for power, TX/RX.

Operating Voltage : 5-12V
  • Availability: 5 In Stock

Write Review

Note: Do not use HTML in the text.